Replacing Shaft Seal for Selector Shaft (GA6HP19Z)

24 14 002 - Replacing shaft seal for selector shaft (GA6HP19Z)





Special tools required:
- 24 5 361 24 5 360 Fixture
- 24 5 362 24 5 360 Fixture
- 24 5 364 24 5 360 Fixture
- 24 5 366 24 5 360 Fixture





Important!
After completion of work, check transmission fluid level.

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Release screws and remove transmission underbody protection (1) (E65 only).
- Remove rear underbody protection (E60/E61 only).





Note:
Version 1:

Unfasten nut.

Remove cable (1).

Installation Note:
Adjusting cable:

- Unfasten nut.
- Adjust cable via holder (2).
Distance A = 1 mm.





Note:
Version 2:

Grip clamping sleeve (1) and slacken nut (2).

Detach retainer (3) towards bottom using a screwdriver.

Pull cable (4) out of holder.

Installation Note:
Adjust selector lever Adjusting Selector Lever (A5S 360R / 390R, A4S 200R, 6HP26Z/19Z).





Note:
Version 3:

Release shift cable head (2) from ball head.

Installation Note:
Adjust selector lever





Release screw.

Take off holder (1).

Tightening torque 24 51 1AZ.

Note:
Illustration shows E65.





Screw in special tool 24 5 361 24 5 360 Fixture until it is firmly connected with shaft seal.





Screw special tool 24 5 362 24 5 360 Fixture onto special tool 24 5 361 24 5 360 Fixture and tighten down.

This pulls the shaft seal out of the transmission housing.





Oil sealing lip on shaft seal (1).

Screw in shaft seal (1) with special tools 24 5 366 24 5 360 Fixture and 24 5 364 24 5 360 Fixture as far as it will go.