Replacing Output Flange Shaft Seal (GA6HP19Z) AWD

24 13 013 - Replacing output flange shaft seal (GA6HP19Z) AWD





Special tools required:
- 23 0 490 23 0 490 Extractor
- 24 4 310 24 4 310 Drift





Important!
After completion of work, check transmission fluid level.

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove transfer box Removing and Installing Transfer Case (ATC 300)





Drive a hole into radial shaft seal (1) using a center punch.

Important!
Do not use a drill as drillings may result in transmission malfunction.

Screw special tool 23 0 490 23 0 490 Extractor into radial shaft seal (1).

Drive out radial shaft seal (1) with impact weight (2).





Installation Note:
Coat sealing lips of new radial seal with clean transmission oil.

Drive shaft seal firmly home with special tool 24 4 310 24 4 310 Drift.