Removing and Installing/Replacing Front Belt Anchor Fitting Tensioner (Driver Seat Only)

72 11 050 - Removing and installing/replacing front belt anchor fitting tensioner (driver seat only)





Warning!
Read and comply with safety regulations [1][2]Safety Regulations For Handling Airbag System Components for handling airbag modules and pyrotechnical belt tensioners.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition!





Necessary preliminary tasks:
- Remove upper rail trim Removing and Installing Outer Upper Rail Trim with Electric Anchor Fitting Tensioner (From 04/04)





Disconnect cable straps.

Installation Note:
Replace faulty cable straps.
Plug connection must not be under tension.

Unfasten plug connection (1) and disconnect.
Release screw (2).
Tightening torque 72 11 08AZ [1][2]Seat Belt Systems.
Remove anchor fitting tensioner (3).

Installation Note:
Secure plug connection with felt strip against unlocking.





If necessary, detach felt.
Using screwdriver, press pin (1) into recess and release anchor fitting (2).

Installation Note:
Anchor fitting (2) is coded.