54 34 ... Removing and Installing/Replacing Support for Clamping Bar on Left or Right

54 34 ... - Removing and installing/replacing support for clamping bar on left or right





Necessary preliminary tasks:
- Move Convertible top out of soft top compartment until support is accessible





Warning!
Soft top becomes pressureless without a warning signal.
For all work, secure soft top with a suitable support tool against collapsing.
Ensure Convertible top is supported in the middle.
Ignition must remain switched off during the repair work.
Failure to comply with this instruction may result in the hydraulic valves incurring preliminary damage.





Release screws (1).
Tightening torque 54 34 10AZ 54 34 Motor-Driven Convertible Top (Electrical Components).
Remove support (2) for tensioning bar.