24 00 050 Installing Replacement Transmission (GA6L45R)

24 00 050 Installing replacement transmission (GA6L45R)





Drain automatic transmission fluid at oil drain plug.

Tightening torque: 24 11 6AZ.





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste disposal regulations

Important!
- Before installing replacement transmission, always flush transmission fluid cooler together with lines.





- After completion of work, check transmission oil level.
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid.
Failure to comply with this instruction will result in serious damage to the transmission.





Necessary preliminary tasks:
^ Remove transfer case (AWD)
^ Remove automatic transmission

Remove transportation lock (1).

Convert all cable holders.

Convert all seal plugs.

Remove protective cap on output shaft.

If necessary, modify transmission support block. Tightening torque 24 71 6AZ.

Important!





After removing transportation lock, secure torque converter against slipping out.

Transmission identification:
- refer to BMW Parts Department.
- On type plate

qv: