Antitheft - Vehicle No Start After CAS3 Replacement

SI B 61 12 07
General Electrical Systems

June 2009
Technical Service

This Service Information bulletin supersedes SI B61 12 07 dated November 2007.

[NEW] designates changes to this revision

SUBJECT
No Crank after CAS3 Replacement

MODEL
E90, E91, E92, E93 (3 Series) vehicles produced from 9/2006

E70 (X5)

[NEW] 71 (X6)

[NEW] E82, E88 (1 Series)

E60, E61 (5 Series) vehicles produced from 3/2007

E63, E64 (6 Series) vehicles produced from 3/2007

SITUATION
After replacing the CAS3 (Car Access System), the vehicle has a "No crank" condition.

CAUSE
The CAS "Line mode" is still active.

[NEW] PROCEDURE

Use ISTA to delete the "Line Mode". Select "Activities/Service function/Drive/CAS/Reset starter interlock", and then run the test plan S6100_KL50MONT.

Note that for the E70 and E71, the Line Mode test plan is not available in ISTA D2.13.x. As an interim arrangement, use DIS V57. Select "Service Functions/Drive/CAS/Reset Starter Interlock" and then follow the test plan.

WARRANTY INFORMATION
For information only





Disclaimer