FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Navigation - CID Stuck on Banner after Programming

SI B 65 49 06
Sound System, Cruise, Alarms, Monitors

December 2006
Technical Service

SUBJECT
CCC: CID Stuck On BMW Banner After Programming

MODEL
E70 (X5) equipped with CCC Navigation (SA 609)

SITUATION
The CID (Central Information Display) is stuck on the BMW Banner after programming of the "RAD/BO". The Final Report indicates that the programming/coding of the "RAD/BO" was successful.

CAUSE
Software error

PROCEDURE
Perform the following procedure using the DIS V48 or later.
1. Perform a short test on the vehicle and page right
2. Select "Function Selection"
3. Select "Service functions"
4. Select "Body"
5. Select "Car Communication Computer"
6. Select "Create boot file again"
7. Select "Test plan"
8. Highlight and select "Create boot file again" test plan and continue
9. The boot file takes approximately 20-45 minutes to regenerate,
10. Finish test plan and recheck operation of the CCC.

WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty.

Defect Code Refer to KSD

Labor Operation: Refer to KSD
Labor Allowance: Refer to KSD





Disclaimer