Replacing Front Left or Right Brake Hose

34 32 881 - Replacing front left or right brake hose





Necessary preliminary tasks:
- Remove wheel Removing or Installing Front or Rear Wheel

After completing work: Bleed braking system Bleeding Brake System with DSC





Press clutch pedal down to floor and secure with pedal support.

Note:
The pedal support may only be released when the brake lines are reconnected.

This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.





Important!
Grip brake hose at square drive to prevent connecting piece from turning in retaining bracket.

Disconnect brake hose from brake line (1).

Installation:
Tightening torque 34 32 1AZ 34 32 Brake Lines.

Important!
Make sure the retaining clip is correctly fitted.

Remove retaining clip (2) and pull brake hose out of holder.
Detach brake hose (3) from brake caliper.

Installation:
Tightening torque 34 32 2AZ 34 32 Brake Lines.





Installation:
First tighten brake hose on brake caliper.

Important!
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.

Move wheels into straight-ahead position.
Insert brake hose in bracket and screw onto brake pipe.

Fit retaining clip.