Replacing Both Rubber Mounts for Stabilizer Mounting

33 55 021 - Replacing both rubber mounts for stabilizer mounting





Important!
Observe safety instructions on raising the vehicle 00 .. ... Lifting Vehicle With A Lifting Platform.
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.

After installation:
- Version with ride-height control: Activate and fill air suspension system Draining/Filling Air Spring System

- Version with Dynamic Drive:

- Fill and bleed hydraulic system

- Check pipe connections for leaks

- Carry out initial Dynamic Drive operation Initial Operation With Test Run of Dynamic Drive

- Adjusting parking brake Adjustments





Necessary preliminary tasks:
- Remove complete rear axle carrier Removing and Installing Complete Rear Axle Carrier





Release screws (1) on both sides.
Tightening torque 33 55 3AZ Rear Axle - Stabilizer Bar.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.

Installation Note:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.