51 46 009 - Removing and installing/replacing decorative strip for oddments tray (back shelf)

51 46 009 - Removing and installing/replacing decorative strip for oddments tray (back shelf)





Special tools required:
- 00 9 317 00 9 317 Trim Panel Wedge





Necessary preliminary tasks:
- Release seat belt at rear middle bottom.





If necessary, unclip decorative strip (1) with special tool 00 9 317 00 9 317 Trim Panel Wedge in direction of arrow.





Installation:
Clip inserts must not be damaged, replace if necessary.

Build date from 02/05:

Additional clip inserts are fitted in area (A).





Unclip seatbelt finisher strip towards front.





Feed out strap with seatbelt finisher strip through opening in decorative strip.





Replacing seatbelt finisher strip:
Feed out seatbelt finisher strip.





Replacement up to build date 02/05:

Note:
Pins (2) must be removed if a new decorative strip (1) with eight pins is fitted to cars with six clip inserts.

Saw off pins (2) with special cutter and max. 63 mm dia. saw blade until flush.