Campaign - Replace High Pressure Fuel Pump

SI B13 02 08
Fuel Systems

September 2008
Technical Service

This Service Information bulletin supersedes SI B13 02 08 dated February 2008.

PERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON ALL
AFFECTED VEHICLES THE NEXT TIME THEY ARE IN THE SHOP FOR MAINTENANCE
OR REPAIRS.

[NEW] designates changes to this revision

SUBJECT
Service Action: Replace the High Pressure Pump

MODEL
E90, E92, and E93 with the N54 engine, produced from 01/17/2007 through 01/25/07

SITUATION
An internal component in the high-pressure pump (HDP) may fail, causing driveability symptoms such as longer starting times or erratic engine operation. It may also lead to a premature failure of the HDP on
vehicles at higher mileages.

Should this situation occur, the HDP emergency operation is activated and the Service Engine Soon lamp (MIL) is illuminated.

Note:
In this situation, the vehicle can continue to be driven, even for long distances, without any risk of breakdown.

AFFECTED VEHICLES
This Service Action involves E90, E92 and E93 vehicles with N54 engines which were produced from 01/17/2007 through 01/25/2007.

In order to determine if a specific vehicle is affected by this Service Action, it will be necessary to utilize the "Service Menu" of DCSnet (Dealer Communication System) or the Key Reader. Based on the response of the system, either proceed with the corrective action or take no further action.








The Chassis Number Ranges listed below are only for informational purposes and are not to be considered as the only deciding factor.

CORRECTION
Replace the high-pressure pump.

PROCEDURE
Please refer to TIS Repair Instruction RA 13 51 017: Removing and installing, or replacing high pressure fuel pump (N54, N53).





PARTS INFORMATION

LABEL INSTRUCTIONS

This Service Action has been assigned code number 514. After the vehicle has been checked and/or corrected, obtain a label (SD 92-335) and:

A. Emboss your BMW center warranty number in the middle of the label (1);

B. Punch out code number 514 (2), printed on the label; and





C. Affix the label to the B pillar as shown.

If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on top of another one because a number from an underlying label could appear in the punched-out hole of the new label.





WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty.





Disclaimer