Removing and Installing/Replacing Control Unit For Dsc (MK60)

34 52 516 Removing and installing/replacing control unit for DSC (MK60)

Special tools required:
^ 32 1 280

DSC (Dynamic Stability Control)

Note:
Read and comply with General Information.
Remove front left wheel.
Remove front left wheel arch cover.

First read out fault memory of control unit and if necessary print diagnostic record.
Installation: On completion, carry out following tasks with the DIS (Diagnosis and Information System):
If control unit is new:
^ Coding
^ Adjustment of steering angle sensor
^ Adjustment of pressure sensors
^ Adjustment of transversal acceleration sensors
^ Function check, hydraulic unit

Important:
Removing pump motor from valve block is not permitted!





Disconnect plug connection (1).
Attach special tool 32 1280 over pump motor and valve block.





Attach retaining clip 32 1 280 first at bottom and then at top over valve block.

Note: Arrow (1) on special tool 32 1 280 must point downwards.

Release screws (2) and remove.






Carefully detach control unit (1) from valve block (2).
Move control unit to rear and then remove to the side through wheel arch.