Replacing One Rubber Mount In the Upper Control Arm (Control Arm Removed)

33 32 671 Replacing one rubber mount in the upper control arm (control arm removed)

Special tools required:
^ 33 3 351
^ 33 3 352

Necessary preliminary tasks:
^ Remove top control arm.





Press out rubber mount with special tools 33 3 351 and 33 3 352.





Place new rubber mount at chamfered end of control arm bore. Here, longer collar (A = 17 mm) of rubber mount must point upwards.
Press in rubber mount with special tools 33 3 351 and 33 3 352 until flush.