Replacing Sealant Bottle of M-Mobility System

Replacing Sealant Bottle of M-Mobility System


Note: This operation describes how to replace the sealant bottle within the framework of inspection (M-Mobility system unused). The control head must also be replaced if the M-Mobility system has already been used.





Pull off sticker for warning V max (1). Omitted if M-Mobility system already used. Lift cover (2) off control head.

Installation:
Replace sticker for warning V max. Replace shelf-life sticker on housing. Make sure cover to control head is correctly positioned.





Release control head (1) with special tool 36 1 080.

Installation:
Tighten down control head with special tool 36 1 080.
Control head to M-Mobility system 15 Nm





Withdraw control head (1) with sealant bottle (2) from housing.
Unscrew control head (1) from sealant bottle (2).

Installation:
Screw control head (1) onto sealant bottle (2) and tighten down with special tool 36 1 080.
Control head to Sealant bottle 2.4 Nm

The control head must be replaced if the M-Mobility system has been used.

Installation:





Check that housing seal (1) and seal for sealant bottle (2) in control head are correctly seated.





Note: Pay attention to expiry date (1) when installing a new sealant bottle. The expiry dates of the sealant bottle (1) and the shelf-life sticker (2) on the housing must be the same.





Make sure connecting leads and accessories are correctly stowed in storage compartment of housing.
^ Electrical connection (1).
^ Compressed air connection with pressure gauge (2).
^ Bag with protective gloves and paper towels (3).