Oil Temperature Sensor/Switch: Service and Repair

Removing And Installing/Replacing Oil Temperature Switch (M52TU/M54)

Turn off ignition.
Release oil filter cap so that engine oil from oil filter can flow back into oil pan.







Remove intake filter housing.

Installation:
Resecure oil filter cap.
Check engine oil level and top up with engine oil if necessary.







Version 1:
Location: On base of oil-filter.


NOTE: Figure shows power steering pump supply tank removed.


Disconnect plug connection (1).
Unscrew oil temperature switch.
Tightening torque, 12 61 1AZ.

Oil Pressure, Oil Temperature, Oil Level Display:

Version 2:
Location: On base of oil-filter.


NOTE: Figure shows power steering pump supply tank removed.


Disconnect plug connection (1).
Unscrew oil temperature switch.
Tightening torque, 12 61 1AZ.

Oil Pressure, Oil Temperature, Oil Level Display: