Replacing Drive Unit For Lumbar Support Front (Sports Seat)

Removing And Installing/Replacing Drive Unit For Lumbar Support On Left Or Right Front Seat (Sports Seat)

Remove rear panel on front seal backrest.







Detach backrest cover (1) from backrest frame (2).







Disconnect plug connection (1).
Detach transparent hose (2) from valve housing (3).


NOTE:
If necessary, gently heat transparent hose (2) if firmly seated.
If necessary, detach fabric adhesive tape (4).


Detach drive unit for lumbar support (5) with jacket towards rear.







Installation:
Clean adhesive area (1) on backrest frame (2).







Transparent hose (1) of drive unit for lumbar support must not be kinked.
Pull off protective film (3) from jacket (2). Stick drive unit for lumbar support to backrest frame.
If necessary, secure jacket (2) with cable strap.