Installing Replacement Transmission (GA6HP19Z) AWD

24 00 050 - Installing replacement transmission (GA6HP19Z) AWD





Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ Transmission Housing, Transmission Oil Sump.





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations





Important!
- Before installing replacement transmission, always flush transmission fluid cooler together with lines Procedures.
- After completion of work, check transmission oil level.
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid.
Failure to comply with this instruction will result in serious damage to the transmission.





Necessary preliminary tasks:
- Remove transfer case Removing and Installing Transfer Case (ATC 300).
- Remove automatic transmission Removing and Installing Automatic Transmission (6HP19Z AWD) N52/N52K/N53





Unfasten screws.
Remove and modify exhaust system bracket (1).





Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.

Important!
After removing transportation lock, secure torque converter against slipping out.

Transmission identification:

- refer to BMW Parts Service.
- on type plate