Audio System - RAD2 Won't Program After An Abort

SI B09 06 06
Programming/Coding Explanations

February 2006
Technical Service

This Service Information bulletin supersedes S.I. B09 06 06 dated January 2006

[NEW] designates changes to this revision

SUBJECT
RAD2 Cannot be Programmed after Programming Abort

MODEL
E90/E91 (3 Series)

SITUATION
After a programming abort on the RAD2 (Radio 2) control module during a
programming session, the final report shows that RAD/BO and/or M-ASK-H have failed to respond. After restarting the programming session, the status report states that one or both control modules need to be replaced.

CAUSE
RAD2 cannot transfer the correct part information to Progman when not programmed correctly.

[NEW]CORRECTION
Progman V20.02.00 or later contains software that allows re-programming of aborted RAD2 control modules.

Progman V20.02.00 was released as an online-update 02/01/2006.