Removing and Installing/Replacing Centering Mount For Propeller Shaft

26 11 090 Removing and installing/replacing centering mount for propeller shaft

Special tools required:
^ 00 5 500
^ 11 1 310
^ 1 12 030

Necessary preliminary tasks:
^ Remove propeller shaft.





Fill centering bore (1) completely with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centering bore.
The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.
If necessary, top up grease repeatedly.

Note: To drive out the mount, you can also fill the centering bore with water instead of grease.





Installation:
Remove grease/water from mount bore.
Drive in centering (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).
Grease centering mount.





Installation:
Observe protrusion A = 4+2 mm of centering (1).