Without Steptronic

Remove/Replacing Shift Lock Solenoid
Without Steptronic





Note: Do not turn handle when pulling off as this would shear off the turning lock in the handle.

Pull off handle with a forceful tug.

Installation:
Attach handle to selector lever.
Align handle and press on until it can be felt snapping into place.





Pull trim (1) out of center console.





Disconnect cable plugs.





Installation:
Adjusting display slide of trim:
^ Press band (1) a little to one side.
^ Press adjuster (2) of display slide (3) against stop (4).
^ Position opening of trim (5) over opening of display slide (3).
^ Move preselector lever to "N" (NORMAL) position.
^ Insert trim on preselector lever and install.
^ Move preselector lever to T" (PARK) position.
^ Display slide (3) is now adjusted.





Release screws.





Lever trim (1) out of center console, disconnect cable plugs (2 ... 3) and remove trim (1).





Remove storage tray (1).





Release screws.





Pull support member (1) slightly out of center console.

Depending on equipment, press fitted switches (2) forwards out of support member (1) and disconnect.

On rear side of support member (1), disconnect cable plug from cigarette lighter and ashtray light.

Remove support member (1).





Detach cable plug from fixture and disconnect.





Release screws.
Tightening torque, 25 16 3AZ.





Lift shift tower (1) and remove acoustic insulation (4) towards bottom.

Lever out locking clip (3). Withdraw shift lock solenoid (2) from shift tower (1).

Installation:
The shift lock solenoid (1) is secured against turning by a flat area on the front journal.