Replacing Output Flange for Front Axle Output (ATC 400/500 X-Drive)

27 10 050 - Replacing output flange for front axle output (ATC 400/500 X-Drive)





Important!
Do not move vehicle with engine power once propeller shaft has been removed.
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check transmission oil level Changing Oil In Transfer Box (ATC 400/500).
Use only approved transmission oil.
Failure to comply with this requirement will result in serious damage to the transfer box!





Operation is identical to Replacing radial shaft seal Replacing Radial Shaft Seal for Front Axle Output (ATC 400/500 X-Drive) for front axle output.