Flywheel: Service and Repair

11 22 000 - Removing and installing/replacing flywheel (N62/N62TU)





Special tools required:
- 11 4 180
- 11 9 260 11 9 260 Counter Support with Screw Connection
- 11 9 262 11 9 260 Counter Support with Screw Connection
- 11 9 263 11 9 260 Counter Support with Screw Connection
- 11 9 264 11 9 260 Counter Support with Screw Connection





Necessary preliminary tasks:
- Remove automatic transmission Removing and Installing Automatic Transmission (6HP26Z).
- Remove manual transmission.
- Remove clutch Service and Repair.





Automatic transmissions only:
Block flywheel (1) with special tools 11 9 260 11 9 260 Counter Support with Screw Connection/ 11 9 263 11 9 260 Counter Support with Screw Connection/ 11 9 264 11 9 260 Counter Support with Screw Connection.
Unfasten flywheel screws.
Remove flywheel (1).

Installation:
Clean threads on flywheel screws in crankshaft.
Flywheel (1) is secured with an alignment pin.
Fit flywheel (1).
Fit new flywheel screws.
Tightening torque 11 22 1AZ 11 22 Flywheel.





Manual transmissions only:
Block flywheel (dual-mass) with special tools 11 9 260 11 9 260 Counter Support with Screw Connection/ 11 9 262 11 9 260 Counter Support with Screw Connection/ 11 9 263 11 9 260 Counter Support with Screw Connection.
Release flywheel screws with special tool 11 4 180.

Installation:
Flywheel (1) is secured with an alignment pin.

Important!
Do not use screw locking varnish.

Tightening torque 11 22 1AZ 11 22 Flywheel.