Replacing Torque Converter Shaft Seal (GA6HP26Z/6HP32Z)

24 31 010 - Replacing torque converter shaft seal (GA6HP26Z/6HP32Z)





Special tools required:
- 00 1 450 00 1 450 Assembly Stand
- 24 0 200 24 0 200 Support
- 24 2 351 24 2 350 Extractor
- 24 2 352 24 2 350 Extractor
- 24 2 353 24 2 350 Extractor
- 24 2 360 24 2 360 Drift





Necessary preliminary tasks:
- Remove automatic transmission Removing and Installing Automatic Transmission (6HP26Z)





Important!
After completion of work, check transmission oil level Checking/Topping Up Fluid Level in Automatic Transmission (GA6HP26Z/6HP32Z).
Use only approved transmission oil.
Failure to comply with this instruction will result in serious damage to the transmission.





Secure transmission with special tool 24 0 200 24 0 200 Support to assembly stand 00 1 450 00 1 450 Assembly Stand.
Remove torque converter Service and Repair.





Attach special tool 24 2 353 24 2 350 Extractor to drive shaft (1).





Screw in special tool 24 2 351 24 2 350 Extractor until it is firmly connected with shaft seal.
Screw in special tool 24 2 352 24 2 350 Extractor to remove shaft seal.





Oil sealing lip on shaft seal.
Drive in shaft seal (1) with special tool 24 2 360 24 2 360 Drift as far as it will go.