Replacing Selector Shaft Seal (GA6HP26Z/6HP32Z)
24 14 001 - Replacing selector shaft seal (GA6HP26Z/6HP32Z)
Special tools required:
- 24 5 361 24 5 360 Fixture
- 24 5 362 24 5 360 Fixture
- 24 5 364 24 5 360 Fixture
- 24 5 366 24 5 360 Fixture
Important!
After completion of work, check transmission fluid level Checking/Topping Up Fluid Level in Automatic Transmission (GA6HP26Z/6HP32Z).
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove underbody protection
E65/M67TU only
Release screws.
Remove transmission underguard (1).
Remove left diesel particulate filter.
E65/N62 only:
Release screws.
Remove transmission underguard (1).
Remove left oxygen sensor Replacing Left Lambda Oxygen Monitor Sensor.
E60/ E63/ E64, N62 only:
Remove rear underbody protection.
Remove left oxygen sensor Replacing Left Lambda Oxygen Monitor Sensor (N62 only).
Note:
Version 1:
Unfasten nut.
Remove cable (1).
Installation Note:
Adjusting cable:
- Release nut
- Adjust cable by means of holder (2)
Distance A ≥ 1 mm.
Note:
Version 2:
Grip clamping sleeve (1) and slacken nut (2).
Tightening torque 25 16 2AZ [1][2]Shifter A/T.
Detach retainer (3) towards bottom using a screwdriver.
Pull cable (4) out of holder.
Installation Note:
Adjust selector lever Adjustments.
Note:
Version 3:
Release shift cable head (2) from ball head.
Installation Note:
Adjust selector lever.
Illustration similar.
Unfasten nut.
Take off holder (1).
Tightening torque 24 51 1AZ [1][2]Shift Linkage, A/T.
Note:
Illustration shows E65.
Screw in special tool 24 5 361 24 5 360 Fixture until it is firmly connected with shaft seal.
Screw special tool 24 5 362 24 5 360 Fixture onto special tool 24 5 361 24 5 360 Fixture and tighten down.
This pulls the shaft seal out of the transmission housing.
Oil sealing lip on shaft seal (1).
Screw in shaft seal (1) with special tools 24 5 366 24 5 360 Fixture and 24 5 364 24 5 360 Fixture as far as it will go.