Replacing Sealing Sleeve for Transmission Housing (GA6HP26Z/6HP32Z)

24 34 020 - Replacing sealing sleeve for transmission housing (GA6HP26Z/6HP32Z)





Special tools required:
- 24 2 390 24 2 390 Covering Cap





Important!
After completion of work, check transmission oil level Checking/Topping Up Fluid Level in Automatic Transmission (GA6HP26Z/6HP32Z).

Use only approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove transmission cross-member.
- Remove transmission sump Service and Repair.

Important!
Support transmission with workshop hoist.





Unlock and disconnect plug (1) by turning.





Insert special tool 24 2 390 24 2 390 Covering Cap in sealing sleeve (1).





Unlock sealing sleeve with slide (1).





Note:
Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation Note:
Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!