Removing and Installing/Replacing Both Front Brake Discs

34 11 220 - Removing and installing/replacing both front brake discs





Special tools required:
- 34 1 280 34 1 280 Sliding Caliper





Necessary preliminary tasks:
- Remove wheels Removing or Installing Front or Rear Wheel
- If necessary, remove and clean brake pads Removing and Installing/Replacing Brake Pads on Both Front Disc Brakes

After completing work, read and comply with notes on braking in new brake discs / brake pads Procedures.

Observe safety instructions on raising the vehicle 00 .. ... Lifting Vehicle With A Lifting Platform.





Check minimum brake disc thickness:

- Position special tool 34 1 280 34 1 280 Sliding Caliper at three measuring points in area (1) and measure.
- Compare measurement result and lowest value with setpoint value Front Brake.
Always replace brake discs in pairs.

If the brake discs are replaced, you must also fit new brake pads.





Important!
New brake pads may only be installed if the brake disc thickness is greater than or equal to the minimum brake disc thickness Front Brake (MIN TH) (not incl. M vehicles).

In the case of M vehicles and perforated brake discs, new brake pads may only be installed if the brake disc thickness is greater than the minimum brake disc thickness Front Brake (MIN TH).

Note:
The minimum brake disc thickness is configured in such a way that it lasts the life of a further set of brake pads (does not apply to M vehicles and perforated brake discs).





Release screws (1), remove brake caliper and tie up.

Installation:
Tightening torque 34 11 2AZ 34 11 Front Brake.

Note:
Brake hose remains connected.

If the brake hose was pulled from the mounting fixture during removal, make sure it is positively attached when installed!





Unscrew bolts and take off brake disc.

Installation:
Tightening torque 34 11 1AZ 34 11 Front Brake.

Clean contact surface of brake disc at wheel hub thoroughly and remove traces of corrosion if necessary. Unevenness on contact surface may result in distortion of brake disc!

Important!
To release brake disc: Do not under any circumstances strike friction ring with a hammer or similar! If necessary, carefully tap on base of brake disc chamber with a rubber mallet.





Important!
Internally ventilated brake discs are balanced.

Never remove or reposition balance clips.