PROM - Programmable Read Only Memory: Technical Service Bulletins

• Recalls
  • Recall 06E-A01 - DME Programming for OBD Diagnostic
    • Overview
    • Owner Letter - MY05 Cars
    • Owner Letter - MY05 X3
• Customer Interest
  • BMW Assist(R) - System Inactive Message is Displayed
  • Bluetooth(R) - Call Displays as Active After Ended
  • Engine Controls - SES Lamp ON/Codes FC094/FC2760/FC2761
  • Engine Controls - Low Speed Idle Dip/Fluctuation
  • Engine Controls - Temp Gauge Goes to Red/DTC P0117 Set
  • Engine Controls - Engine Power Drop At 4,000 RPM
  • A/T Controls - Warning Lamp ON/DTC's Stored
  • Engine Controls - Power Drop at 4,000 RPM
• All Technical Service Bulletins
  • Computers, Controls - Programming VS Veh. Data Status
  • Engine Controls - DME Programming Tips
  • BMW Assist(R) - System Inactive Message is Displayed
  • Progman(R) - Programming/Coding/Individualization
    • Overview
    • General_Rules_For_Programming
    • Procedure_A_Module_Replacement
    • Procedure_B_Software_Update
    • Procedure_C_Troubleshooting
      • Index
      • Introduction
      • Section I: Preparing A Progman Session
      • Section II: Progman Session Initialization
      • Section III: Before Programming/Coding
      • Section IV: After Programming Coding
      • Illustrations and Table
    • Procedure_E_Coding
  • Bluetooth(R) - Call Displays as Active After Ended
  • Recall 06E-A01 - DME Programming for OBD Diagnostic
    • Overview
    • Owner Letter - MY05 Cars
    • Owner Letter - MY05 X3
  • Computers/Controls - 'Retrofit' Update Programming
  • Engine Controls - SES Lamp ON/Codes FC094/FC2760/FC2761
  • Engine Controls - Low Speed Idle Dip/Fluctuation
  • Engine Controls - Temp Gauge Goes to Red/DTC P0117 Set
  • Engine Controls - Engine Power Drop At 4,000 RPM
  • Computers/Controls - Progman(R) V22.0/V22.0.1 Errors
  • Engine Controls - Progman(R) V21.01 and V21.02.01 Errors
  • A/T Controls - Warning Lamp ON/DTC's Stored
  • Engine Controls - Power Drop at 4,000 RPM