Engine Controls - EML/DSC/EGS Lamps ON/FC 211

SI B 12 28 05
Engine Electrical Systems

December 2005
Technical Service

SUBJECT
MY '05 325xiA - DME Fault Code 211

MODEL
E46 M54; 325xiA produced 09/04 up to 02/05

SITUATION
Customer may complain that intermittently EML, DSC and EGS lights are illuminated while driving. No drivability problems are experienced with the warning lights flashing.

The following fault codes are stored in the control modules:

^ DME - FC 211; Idle speed control valve stuck open

^ DSC - FC 145; CAN torque reduction

^ EGS - FC 76; Engine does not fulfill torque request.

CAUSE

DME software

CORRECTION

On a customer complaint basis only, reprogram DME with CIP 20.0, or higher.

CIP 20.0 is planned for release at the end of December '05.

Important:
Prior to CIP 20.0 release, and when encountering a critical customer situation, contact Technical Hotline - Drivetrain via a PUMA case, requesting authorization for DME shipment for reprogramming. For a title use: "325xi FC 211.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle Limited Warranty.

For the appropriate labor operation and allowance refer to KSD system.





Disclaimer