34 33 505 Removing and Installing/Replacing Brake Unit (MK60)

34 33 505 Removing and Installing/Replacing Brake Unit (MK60)

DSC (Dynamic Stability Control)

Note:
Read and comply with General Information
Bleed brake system after completing tasks
Remove brake master cylinder Brake Master Cylinder
Remove DSC3 precharging pump Hydraulic Control Assembly - Antilock Brakes
Remove cover from electrical box.
Remove brake pedal Brake Pedal Assy

Note:
General Information.
After completing work:
Bleed brake system with DSC.

Remove brake master cylinder for DSC (MK60)
Remove DSC hydraulic unit (MK60)
Remove brake pedal





Unscrew nuts (1)

Installation:
Replace self-locking nuts.
Tightening torque: 25 Nm

Note: Do not use any force when removing and installing the brake unit; the brake unit can be damaged under certain circumstances.





Carefully remove brake unit (1) from bulkhead and tilt out in direction of engine





Remove brake unit vertically upwards out of equipment compartment