51 14 110 - Removing and installing/replacing rear model designation

51 14 110 Removing And Installing/replacing Rear Model Designation

IMPORTANT: The "Instructions for number/letter combination cementing" serve as the basis for these repair instructions and must be followed without fail.

Fitting dimensions for Saloon:







Stick on adhesive tape up to top edge "A" and mark out measurement "B".

Saloon 316 i ... 330 i:
A = 50 mm
B = 25 mm

Saloon 318 d ... 330 d:
A = 50 mm
B = 25 mm

Fitting dimensions for Coupe and Convertible:







Stick on adhesive tape up to top edge "A" and mark out measurement "B".







Fitting dimensions for Touring:







Stick on adhesive tape (1) from edge of rear lid (2) up to top edge measurement "A" and mark out measurement "B".
Observe measurement "C" when sticking on number/letter combination.

Touring 316 i ... 330 i:
A = 35 mm
B = 25 mm
C = 1 mm

Touring 318 d ... 330 d:
A = 35 mm
B = 25 mm
C = 1 mm

Touring 325 xi, 330 xi, 330 xd:
A = 35 mm
B = 25 mm
C = 1 mm

Fitting dimensions for Compact:







Stick on adhesive tape (1) from edge of rear lid (2) up to measurement "A" and mark out measurement "B".
Observe measurement "C" when sticking on number/letter combination.

Compact 316 ti ... 325 ti:
A = 41 mm
B = 134.5 mm
C = 1 mm

Compact 318 td, 320 td:
A = 41 mm
B = 134.5 mm
C = 1 mm