General Electrical New Features

General Electrical New Features
KBM (Body Base Module)
The KBM controls the following functions:
^ Rear Power Windows
^ Central Locking (Rear Doors, Trunk/Tailgate and Fuel Filler Flap)
^ Windshield Wiping/Wash System
^ Interior Lighting
^ Consumer Shutdown

Door Modules
The Door Module is integrated into the ASK. It communicates with other vehicle systems via the byteflight.
The Door Modules contain the following functions:
^ Mirror Adjustment, Heating, Memory, Folding and Lighting
^ Central Locking (Front Doors Only)
^ Front Power Windows (with indirect anti-trapping)
^ Connection to Drivers Door Switch Block
^ Connection to Passengers Door Power Window Switch)
^ Door Entry Lights and Switch Illumination
^ Recording of Front Door Pressure Sensor Information

The Car Access System (CAS2) is based on the CAS of the E65, however in the E60 the ignitions starter switch and the CAS are two separate components. The E60 CAS is connected directly to the K-Bus and does not perform any repeater functions.

PDC
The signal from the PDC button is forwarded to the PDC Control Unit via the K-CAN.

Roller Sun Blind
The rear window roller sunblind is controlled from the center console switch panel. The roller sun blinds for the side windows are manually operated.


Multifunction Seat
The multifunction seat makes it easier to get in and out of the vehicle. The backrest width and seat cushion depth are retracted for this purpose.


KBM








Located in the equipment frame at the clove box. the KBM has 4 electrical connectors (X13252 54-pin, X13254 3-pin, X13253 13-pin, X13255 6-pin) and an operating voltage range of 9-16 Volts. The KBM is internally protected against shorts to terminal 30 or 31 and equipped with reverse polarity protection.