S5D 260Z/310Z/320Z Transmission

Replacing Drive Shaft Radial Seal (S5D 260Z/310Z/320Z)
Special Tools Required:
^ 23 0 490
^ 23 2 340
^ 23 2 380

Note: After completion of work, check transmission oil level.

Caution: Use only the approved gear oil in this manual transmission.

Failure to comply with this requirement will result in serious damage to the transmission.

Transmission removed.

Remove release unit and release lever.





Unfasten screws and remove guide tube.






Note: Two covered removal holes (1) are located on the end face of the radial sealing ring.





Screw special tool 23 0 490 into one of two removal holes.
Pull radial sealing ring out of transmission housing with impact weight.





Fit special tool 23 2 380 onto transmission input shaft.

Coat sealing lips of new radial seal (1) with transmission oil and slide firmly home on transmission case. Remove special tool 23 2 380 from drive shaft.





Drive radial seal (1) firmly home with special tool 23 2 340.

Note: To drive in: use a plastic hammer.