S5D 260Z/310Z Transmission

Replacing Radial Seal For Output Flange (S5D 260Z/310Z)
Special Tools Required:
^ 00 5 010
^ 23 0 020
^ 23 2 300
^ 23 2 320
^ 33 1 150

Note: After completion of work, check transmission oil level.

Caution:
^ Use only the approved gear oil in this manual transmission.
^ Failure to comply with this requirement will result in serious damage to the transmission.

Unflange propeller shaft from transmission and tie up to one side.





Support transmission with a workshop hoist. Unfasten screws and remove cross member.

Installation:






Brace output flange with special tool 23 0 020.

Release collar nut (1) with special tool 23 2 320 .

Installation:
Install collar nut (1) with screw retaining compound.
For compound.






Detach output flange with special tool 33 1 150 from output shaft.

Installation:

Heat output flange to approximately 80°C and push onto output shaft.





Remove radial seal with special tool 00 5 010 .





Coat sealing lips of new radial seal (3) with transmission oil. Drive radial seal (3) home flush with special tool 23 2 300.

Note: To drive in: use a plastic hammer.