Replacing Boot - Constant Velocity Joint Removed

Replacing Boot - Constant-velocity Joint Removed





Drive out cheese-head bolts using a plastic hammer.

Remove washers.





Pull or knock off end cover (1).

Watch out for seal (2) between constant-velocity joint and end cover.

Check grease filling, adding grease if necessary.
Refer to Technical Data.





Mount new end cover and boot on propeller shaft or on constant velocity joint.

Install washers and cheese-head bolts. Drive in cheese-head bolts to fit tightly using a plastic hammer.





Pull boot onto propeller shaft.

Install hose clamp on boot and tighten.