Version Without Slide

Replacing Complete Propeller Shaft Center Mount - Version Without Slide





Remove propeller shaft.
Refer to 26 11 000

Mark installed position of front propeller-shaft section to rear propeller-shaft section.

Caution: Propeller shaft was balanced in assembled state so that propeller-shaft sections must not be turned when re-installed.





Unscrew bolt (1).

Pull off front section of propeller shaft.

Installation note:
Assemble propeller shaft in such a way that punch marks are located on opposite sides.
Secure screw (1) with screw retainer.





Pull off center mount complete with grooved ball bearing using a standard puller.

Installation note:





Pay attention to installed direction of dust cover (2).





Press grooved ball bearing (3) into center mount.





Drive on center mount with ball bearing using Special Tool 24 1 040.

Caution: Check center mount for ease of movement.