Defect Code 60, 61

Defect Codes 60, 61:

*D* Defect code memory: 60, 61 Valve Coil Defects:

Note: The EDC control unit can only register faults in the electrical/electronic system. Mechanical damage of the damper valves (e.g. catching) cannot be detected by the control unit.

Determine damper valve in question by reading out the measured values (status monitoring or during troubleshooting) and by alternately detaching the connections at the damper (connector at front right left and rear right' left on damper).

If the cause of the defect is not found with the aid of the following troubleshooting procedure, there could be mechanical damage to the damper system (e.g. solenoid valves).

Troubleshooting: Check valve control wires and repair if necessary:

- Comfort front: From 10-pin control unit connector Pin 1 to corresponding Left/right damper valve.
- Comfort rear: From 10-pin control unit connector Pin 3 to corresponding left/right damper valve
- Normal front: From 10-pin control unit connector Pin 2 to corresponding left/right damper valve
- Normal rear: From 10-pin control unit connector Pin 5 to corresponding left/right damper valve.