Shift Solenoid: Service and Repair

REPLACING ALL SOLENOID VALVES





Solenoid Valve (32) 2nd/3rd Gear
Remove
- Remove transmission oil pans, Service and Repair
- Press off plug (1) with screwdriver
- Do not pull on wires
- Pull out pin (2) (use side cutters)





- Pull or press (use screwdriver) out solenoid valve.

Installation
- Coat seals with grease (Vaseline)
- Press in solenoid valve as far as stop
- Replace clamping pin (2)
- Pin must protrude about 5 mm





Solenoid Valve (33) 1st/2nd And 3rd/4th Gear
Remove
- Press off plug (1) with screwdriver.
- Do not pull on wires.
- Pull out pin (2) (use side cutters).





- Pull or press (use screwdriver) out solenoid valve.

Installation
- Coat seals with grease (Vaseline)
- Press in solenoid valve as far as stop
- Replace clamping pin (2)
- Pin must protrude about 5 mm






Solenoid Valve (29) Brake Band
Remove
- Remove oil screen
- Press off plug (1) with screwdriver.
- Do not pull on wires.
- Press in solenoid valve - light spring pressure - and pull out pin (2) by hand or with a pliers if necessary.





- Pull out solenoid valve.
- Avoid damage to corrugated washer (3)





Installation
- Coat seals with grease (Vaseline).
- Install solenoid valve that groove (4) is aligned with bore (5).
- Press in solenoid valve that pin (2) can be inserted.





Solenoid Valve (38) Torque Converter Clutch
- Press off plug with screwdriver
- Do not pull on wires
- Remove screw

CAUTION: Imperial threads

- Pull or press (use screwdriver) out solenoid valve.

Installation
- Coat seals with grease (Vaseline)
- Press in solenoid valve as far as stop and tighten screw to 6 - 8 ft. lbs. (8 - 11Nm)
- Reinstall transmission oil pans.
- Refill transmission.Service and Repair