Loading Instructions For Tis

1. At the DIS main screen select "Administration."
2. Select "TIS Administration."
3. Highlight the TIS drive, then press "CD-ROM Deactivate."
4. Remove TIS carrier and replace old TIS CD with new TIS CD (never touch the top or bottom surface of a CD, only handle the sides).
5. Replace TIS carrier.
6. Highlight TIS drive (screen will say "Not Active").
7. Select "CD-ROM Activate."
8. Select "TIS Installation."
9. Select "Hard Disk & CD ROM."
10. Select "OK."
11. Loading time takes approximately 3 hours.
12. When the cursor appears on the screen, switch the DIS monitor power switch off.
13. When the DIS is powered down, press the monitor switch again to reboot the system.