Fuel Pressure Regulator: Service and Repair
Remove and Install1. Remove the fuel injector insulation cover.
2. Disconnect the vacuum hose.
Fuel Pressure Regulator Location:
3. Unscrew the fuel pressure regulator clamp bolt and remove the clamp.
WARNING: With the ignition "OFF", carefully bleed off residual fuel pressure by loosening the inlet hose to the fuel injector rail. Prevent fuel from coming into contact with hot engine components.
NOTE: The fuel pressure regulator is located at the rear of the fuel injector rail near the firewall.
4. Pull the fuel pressure regulator from the injection rail.
5. Check for the proper I.D. code number on the fuel pressure regulator.
6. Replace seals.
7. Reinstall in the reverse manner.