Procedure 4

Recoding ZAE control module: To be performed on 1994 325 models only.

Use only MoDiC Coding Diskette V11.2 or higher to modify the deployment time of the ZAE control module using the usual coding procedure. The new information is transmitted through # 19 Airbag in the recoding section.

Note:
Ignition may not be turned off during recoding.

Load MoDiC with coding discs A and B.

^ Connect MoDiC to vehicle's diagnostic connector

^ Turn on ignition

^ Select "Coding ZCS"

^ Enter current date

^ Select "4 Series E36"

^ Select "1 Recoding"

^ Select "19 Airbag" and confirm - press "enter"

^ Start automatic coding - press "Y"

^ After recoding is complete (approx. 10 min.), turn ignition off. Wait at least 10 seconds, then turn ignition on again

^ Turn ignition off and disconnect MoDiC