Service Action Label Instructions and Warranty Info.
Service Action LabelInstructions:
In order to keep the "B" pillar as neat and uncluttered as possible, maximize the use of each label by punching all applicable campaigns on the same label(s).
If a particular vehicle has an existing label on the "B" pillar from your dealership, proceed as follows:
- Note the number(s) punched out on the old label(s)
- Punch out the same number(s) on the new label(s), including all applicable campaign numbers being performed
- Carefully remove the old label(s) and affix the new label(s) to the "B" pillar.
If no existing label from your dealership is found, a new label must be used.
Do not remove labels which have other dealer numbers.
This Service Action campaign has been assigned code number 85. After the prescribed work has been performed, obtain a label (SD 92-008) and:
a) emboss your BMW dealer warranty number in the middle of the label;
b) punch out code number 85 printed on the label (and any other applicable number(s), as described above;
c) bend label to crease an edge, and remove the backing paper. Then affix it to the driver's side "B" pillar as shown.
Do not affix one label on top of another one because a number from an underlying label could appear in the punched out hole of the new label.
Warranty
Information:
Covered under the terms of the BMW New Car Limited Warranty. Reimbursement for this Service Action will be provided through Campaign Entry.
Special Defect Code: 00 11 01 30 00
Work Package # 1 -
Checking VANOS production date code (no further action required).
Labor Allowance: 3 FRU
Work Package # 2 -
- Checking VANOS production date code
- Torquing solenoid valve
- Checking clearance-replacement not necessary
Labor Operation: 00 55 407
Labor Allowance: 5 FRU
Work Package # 3 -
- Checking VANOS production date code
- Torquing solenoid valve
- Checking clearance
- Replace solenoid valve
Labor Operation: 00 55 408
Labor Allowance: 5 FRU
Part Allowance:
11 36 1 738 494 Qty. = 1 Solenoid Valve