Steering Gear Replace

Before commencing any work, Service Precautions
1. On models equipped with airbag, disable restraint system, .
2. Ensure steering wheel is centered and front wheels are in straight ahead position, then raise and support vehicle and remove front wheels.
3. Scribe matching marks between steering shaft joint coupling and steering gear housing, loosen pinch bolt and pry coupling off steering gear spindle.
4. Disconnect fluid pressure and return hoses from steering gear, drain fluid into suitable container, then plug lines and open fittings. Do not reuse power steering fluid.
5. Remove nuts securing tie rods to spring struts and disconnect tie rods using suitable puller.
6. Remove bolts securing gear to crossmember and the steering gear.
7. Reverse procedure to install, noting the following:
a. Replace self locking nuts during installation.
b. Tighten steering gear bolts and tie rod retaining nuts to specifications.
c. Ensure steering shaft joint is properly aligned and pinch bolt is engaged in groove, then tighten to specifications.