Wiring Harness: Service and Repair

Replacing Wire Harness For Automatic Transmission




- Remove valve body. Service and Repair
- Pull off wire harness plugs on solenoids (1...4), pressure regulator (5) and pulse transmitter (6).
- Lift wire harness out of holders.
Installation:
- Check colors of wires.
- Solenoid (1) - gray/violet
- Solenoid (2) - green/violet
- Solenoid (3) - red/violet
- Solenoid (4) - orange/violet
- Pressure regulator (5) - blue/violet
- Pulse transmitter (6) - brown/brown
- Push on plugs against stop and check for tight fit.




- Route wire harness and clamp in holders (7... 10).




- Turn valve body around.
- Route wire harness and clamp in holders (11...14).