Primary Connector With Special Connector Systems

Primary Connector With Special Connector Systems

Procedure

• If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to=> [ Secondary Lock ] Secondary Lock.

Fasten Contacts






- Guide the release tool which fits the connector housing into release channel on connector housing - arrow -.

- Grasp contact at wire and push it gently into connector housing.

• By pushing the contact in the direction of the connector housing, contact retaining tabs are lifted off the housing shoulder and can be released using the release tool.

- At the same time, push the release tool in the direction of the connector housing and pull the released contact out of the connector housing - arrow -.






- Remove the release tool after removing the contact from the housing.

GT 150/280 Contacts






- Guide the release tool which fits the connector housing under retaining tab into connector housing.

- Push tool into connector housing until it stops - arrow -.

• Contact is ejected from the connector housing.






- Remove the release tool after removing the contact from the housing.

Contacts Without Retaining Tabs






- Insert release tool under retaining tab of connector housing.

- Push release tool through until it stops by gently lifting - arrow -.

• Contact is ejected from the connector housing.






- Remove the release tool after removing the contact from the housing.