Protecting

Protecting

Special tools, testers and auxiliary items required

• Contact Surfaces Cleaning Set (VAS 6410)

• Using the Contact surface cleaning set VAS 6410 (VAS 6410) , service work can be performed in the area of the contact sensor on the threaded connection wiring harnesses in the high current circuit (starter and charging current).

• The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable for "hard surfaces".

Danger of corrosion.

• Missing protection leads to the electrical system damage.

• All threaded connections must be tightened to the specified torque.

• Always use the accompanying hose on the protection container.

• Protection wax is used in the cool area and cavity protection wax is used in the warm area.

• The protection material draws itself into the affected places by capillary action.

- Hold the injector under the wiring eyelet and spray all around the pins.






- Hold the injector above the wiring eyelet and spray all around the pins and wiring eyelet.