Left Instrument Panel Fuse Holder

Left Instrument Panel Fuse Holder

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing






- With ignition switched off, disconnect battery Ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove driver side instrument panel cover. Refer to Storage Compartments and Covers.

- Remove bolts - arrows - for fuse panel - 1 -.

- Remove fuse panel from central tube for instrument panel.

- Release cover for fuse panel - arrows -.






- Remove the fuses from the fuse panel.

- Unclip socket and remove connectors from fuse panel.

• Check the exact assignment for fuse panel in the current wiring diagram.

Installing






• Tightening specification, refer to => [ Relay Carrier and Fuse Panel Overview ] Relay Carrier and Fuse Panel Overview.

Install in reverse order of removal. Note the following:

- Make sure the fuse panel - 2 - sits at the top of the central tube behind the mount - 1 -.

- Install driver side instrument panel cover. Refer to Storage Compartments and Covers.

- Connect battery. Refer to => [ Connecting ] Battery, Disconnecting and Connecting.