Left Footwell Vent Temperature Sensor (G261)

Left Footwell Vent Temperature Sensor (G261)

• On vehicles with heating (without A/C system), there is no Left Footwell Vent Temperature Sensor installed (depending on version, mounting opening in air guide channel is not present or is sealed with sealing plugs).

- Remove driver side storage compartment.

- Remove left footwell vent - A - (driver side).






- Reach through opening between left side of A/C unit and central tube (instrument panel cross member) or support on left side of A/C unit and rotate sensor - B - into position in which connector - A - can be disconnected.

- Disconnect the connector - A - (for example, using needle-nose pliers)






- Turn sensor - B - 90° and pull it out of A/C unit.

- Check seal - C - for proper seating when installing.

• If the sensor - B - cannot be rotated, or is not accessible because of other components - B -, remove this component.

• This illustration depicts sensor - B - with instrument panel removed. With instrument panel installed, the sensor - B - is visible from underneath when the footwell vent is removed (part of sensor with temperature sensor is visible in air guide channel).