Rear Brake Caliper Assembly Overview

Rear Brake Caliper Assembly Overview






1 - Bolt

• Self-locking

• Always replace after removal.

• When loosening and tightening, counter-hold at guide pin.

• 35 Nm

2 - Bleeder Screw

• Apply a thin coat of lithium grease (G 052 150 A2) to the threads before screwing in.

• 10 Nm

3 - Protective Cap

4 - Guide Pins

• Grease before pulling on protective cap.

5 - Protective Cap

• Pull onto brake carrier and guide pin.

6 - Brake Carrier with Guide Pins and Protective Cap

• Supplied as an assembled replacement part with sufficient grease on guide pins.

• If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.

7 - Protective Cap

• Pull onto piston with outer sealing lip

8 - Piston with Automatic Adjustment

• Removing and installing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

• Apply thin coat of lithium grease (G 052 150 A2) to piston.

9 - Seal

• Do not damage when installing piston.

• Removing and installing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

10 - Brake Caliper Housing with Parking Brake Cable Lever

• Replace if leaking at parking brake cable lever.

• Pre-bleed caliper housing after repairing. Refer to => [ Pre-Bleed Brake Caliper ] Rear Brake Caliper Piston.