Trim, Coupe

Rear Cross Panel Trim

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)






Removing

- Remove the rear lid end panel trim panel - 1 - vertically and upward using the trim removal wedge (3409).






Installation

Install in reverse order of removal. Note the following:

• Check clips for damage or deformation and replace if necessary.

- Position the rear lid end panel trim panel - 1 - so that the left and right brackets fit into the holes - 3 - and into the eyes - 4 -.

- Stretch the rear lid seal - 2 - over the rear lid end panel trim panel - 1 -.