Trim Panel: Description and Operation

Rear Bulkhead Cover Assembly Overview






1 Rear bulkhead cover

• Removing and Installing, refer to => [ Rear Bulkhead Cover ] Rear Bulkhead Cover

2 Seat belt

3 Rollover protection trim

• Must be installed before installing rear bulkhead cover

4 Linkage removal flap

• For convertible top

• Is closed when in basic position

5 Left rear panel trim panel

• Must be installed before installing rear bulkhead cover

6 Clips

• Quantity: 6

• Install into the rollover protection trim

• Must be installed before installing rear bulkhead cover

7 Right rear panel trim panel

• Must be installed before installing rear bulkhead cover

8 Wind deflector

• Only the wind deflector support is installed on some vehicles => [ (Item 2) Wind deflector support ] Wind Deflector Assembly Overview, note corresponding equipment

9 Clips

• Quantity: 6

• Press into rear bulkhead cover

• Must engage with wind deflector of wind deflector support => [ (Item 8) Wind deflector ] when installing rear bulkhead cover

10 Clips

• Insert in rear bulkhead cover

11 Bolt

• 0.6 Nm

12 Belt extraction panel

• Removing and Installing, refer to => [ Removing ] Belt Extraction Panel